Energy efficiency improvements are the short-term answer to today's energy crisis!
Over the next few decades, cleaner and more sustainable energy sources will gradually become available on a larger scale. Until then,
the energy-efficiency improvements of today's systems are by far the quickest, most affordable and most effective way to reduce CO2 emissions and lower your energy bill.
And the good thing is: It's easy with an AIRCOSAVER!
- is an electronic control unit that adds intelligence to existing air conditioning systems (retrofit) and improves their energy efficiency;
- achieves average energy savings of about 20% (depending on local
conditions up to 30% or more) resulting in a short payback period;
- is engineered & manufactured in Germany to highest quality
standards to give you peace of mind;
- has been tested and installed successfully by various prestigious
blue chip clients and leading authorities;
- is a proven product with a large installed base across different climates that has been growing by many thousand units each year since 2001.
The Intelligent Geyser or so called I-Geyser (heat pump geyser) works much like a refrigerator in reverse. The heat pump extracts heat from the air, intensifies the heat with a compressor, delivers the heat to water and expels the cooler air to where you can use it. Because it uses warm ambient air to do most of the work, it's a very efficient way to heat water. Triple
the efficiency of a standard geyser.
Ratio of power input to power output: 3.6
- Uses heat-pump technology for superb energy efficiency, cutting your energy bill by up to 72%.
- For every 1kWh you put in, water is heated by 3.6kWh.
- Works with eco friendly, R134a refrigerant, which is not harmful to the ozone.
- Provides free cooling you can utilise by ducting the supply air into an adjacent room (MWH-300 only).
- An easy to use LED touch pad allows you to choose the best of 3 modes.
- The ideal choice for replacement of power-hungry electric geysers in all buildings.
- Works even when weather conditions are not favourable, unlike solar geysers, which need
auxiliary elements, so costing you money when it's cloudy.
The inverter technology is integrated in the outdoor unit. The inverter technology can be compared to the technology in a car: " The harder you push your accelerator, the faster you go."
An inverter unit will gradually increase its capacity based on the capacity needed in the room to cool down or heat up the room. The non-inverter can be compared with switching on or off a lamp.
On switching on this type of unit it will start to run on full load.
Advantages of the inverter technology:
- You reach much faster the comfort temperature you want.
- The start-up time is reduced by one third.
- You save a lot of energy and money : up to 30% less power consumption.
- Avoids cycling of the compressor avoiding voltage peaks.
- The energy consumption cost is reduced by one third (compared to normal on/off units).
- No temperature fluctuations.
VRV systems feature highly intelligent inverter-driven compressors that allows for individual control of up to 24 indoor fan coil units. Fully optimized to operate with R-410A refrigerant, the system's technology enables the output of the outdoor unit to be modulated by the cooling or heating demand of the zones it controls.
The heat recovery function is achieved by diverting exhaust heat from indoor units in cooling mode to areas requiring heating. The VRV system keeps running cost at an absolute minimum by controlling each zone individually and shutting down completely in unoccupied areas if required.
More compact than conventional outdoor units, our heat-recovery units can be easily transported via elevator. In the unlikely event of a compressor malfunction, the backup function takes over to deliver 50-percent capacity during emergency operation, eliminating the need for expensive standby equipment.
Features:
- Heat-recovery technology enables either cooling or heating from one system.
- Up to 24 indoor fan coil units connected to an outdoor unit.
- Cooling capacity of 6 / 8 / 12 / 14 / 16 Tons available.
- Up to 1,024 indoor units can be operated on a single wiring system.
- Continuous operation -17 Degrees Celsius to -53 Degrees
Celsius in heating mode and -5 Degrees Celsius to 43 Degrees
Celsius in cooling mode.
- Flexible piping lengths of up to 152m for a total combined length of 305m.
- Anticorrosion treatment.
- Branch selector boxes are necessary to switch a specific unit or a
group of indoor units from cooling to heating mode.
Copyright Globe Air 2010 | All rights reserved | Powered by the IIS Group
 |
|
